Sasha

Tried to 3D print a case to hold my 7″ screen that I use for FPV on my hexacopter. The case is meant to hold a battery, the screen, and the receiver unit all together and then it optionally clips onto the top of my controller transmitter. Unfortunately Makerbot somehow scaled everything to 80% even though makerware confirms the correct size. I probably won’t have the chance to try to print again until I get back to my own printer awaiting me in MN. Also noticed a lot of warping on both pieces. Once I re-print the design I’ll post files up for anyone that wants one. Also may touch up the designs because this was literally done in 30 mins. Just enough time to copy dimensions over and stuff.

20140730_11581120140730_172537

Filed under: Uncategorized

JUMP TO TOP

Lucina / Chrom Sword (Fire Emblem)

 

About this site:

This is my personal webpage where I store documents and document projects and project ideas, maybe there is an idea for a store :)

I sometimes block all emails, messages, and comments from this site depending on how well the spam shields are holding. The most assured way of contacting me is through my youtube channel, my instructables account, or my thingiverse profile (probably in that order).

Calculating sub-orbital trajectories...